Time to install the new Titan extruders. The original extruder design was all-metal, but this time I'd like to incorporate some prin...
Thursday, 5 October 2017
Tuesday, 3 October 2017
Assembly VIII: Side Panels
I'd like to clean up the printer a bit before working on the extruders, so I decided to install the side panels. The side panels serve...
Monday, 2 October 2017
Extruder Investigation
I plan on addressing the extruder banding problem by replacing the entire extruder assembly, but first I'd like to investigate the so...
Tuesday, 26 September 2017
First Prints
I'm not a huge fan of testing complex projects because probability makes it quite likely that something will go wrong. That being sa...
Monday, 18 September 2017
Assembly VII: Extruder Wiring
The final assembly task is to connect the extruder wiring to the Smoothieboard. I did this in a slightly roundabout way so that it will b...
Thursday, 13 July 2017
Assembly VI: Final Alignments
I spent quite a bit of time getting the electronics running, so its finally time to bring the mechanical side of the printer up to speed ...
Subscribe to:
Posts (Atom)